• This unit is made up of the main components found in a typical hydraulic installation.
  
• A differential pressure sensor with a display can easily be connected at various points in the circuit to take measurements.
  
• Transparent tubes are used to show the flow of hydraulic fluid.
  
• By adjusting the pressure or flow rate, laminar or turbulent flow can be displayed.
  
• Closed circuit operation.
  
• Manufactured and designed to industrial standards.

COMPONENTS TO BE STUDIED

• 3 horizontal pipes: DN15 - DN25 – DN40 length : 1000 mm – pressure measurement for the changing of the pipe's length

• 1 horizontal rough pipe: DN25
  Length: 1000 mm
  Various bend: short horizontal radius bend - 45° bend – 90° bend - 135° horizontal bend
• 1 pipe with horizontal membrane valve
• 1 pipe with global step valve (spherical «dome»)and 1 pipe with inclined horizontal seat valve
• 1 pipe with horizontal diaphragm and venturi
• 1 pipe with reduction from DN25 to DN15 (horizontal) and increase from DN15 to DN25 (horizontal)