- 1000V, 600mA, 300Watts
- Settings by tactile switches
- Constant voltage
- Constant current
- Timer : 0-9999 minutes
- Last settings are automatically restored at power
up.
- Two red LEDs indicate the constant parameter. The
units may be operated in timed mode and will automatically terminate
output. Continuous mode may also be operated.
- It is possible to perform electrophoresis with
constant current whilst limiting the voltage to a selected value
or with constant voltage whilst limiting the current to a
selected value.
- If one of the non controlling output set values
is reached during the run, the power supply will automatically crossover
and control the output relative to that parameter.
- Automatic RESTART in case of power failure during
a cycle. When the power returns, an audible safety alarm rings for
10 seconds then the START mode turns on automatically at the preset
values.
- Three safety outlets.
- These microprocessor controlled power supplies
are equipped with a circuit breaker which automatically cuts the
electrical supply in case of ground leakage detection, (500mA) short
circuit, open circuit (no load connected) or overload.
|
