• 1000V, 600mA, 300Watts
• Integrator - Timer
• Last settings are automatically restored at power up
• When output supply stops, a specific message is displayed.
• Twenty switch keyboard for monitoring each function.
• Four operating modes : Constant voltage, constant current, constant power or temperature limitation.
• It is possible to perform electrophoresis with a constant parameter whilst limiting the others to selected values, including temperature.
• Automatic crossover from one mode to another when output limits are reached. Flashing display indicates the constant mode.
• Automatic RESTART in case of power failure during a cycle. When the power returns, an audible safety  alarm rings for 10 seconds then, the START mode turns on automatically at the preset values.
• Recommended for over night  electrophoresis.
• Automatic storage of the preset and elapsed values (minutes and V/Hr) in case of power failure or voluntary interruption during a cycle.
• This microprocessor controlled power supply is equipped with a circuit breaker which automatically cuts the electrical supply in case of ground leakage detection, (500mA) short circuit, open circuit or overload.
• Specific messages are displayed.

• 16 'one step' programs with automatic preset cut off.
• 8 programs with up to 9 steps which automatically follow preset values for each step.
• 1 specific program for low current <15mA .
• LCD display with 2 lines of 20 characters.

10-1000V / 10V
15µA-600mA / 1mA
0.3-300watts / 1watt
0-99°C / 1°C
1-99999V-hour / 1V-hour
1-9999min. / 1min.