• 200V, 1998mA, 300Watts
• Constant voltage
• Constant cuurent
• Timer : 0-9999 minutes
• Two red LEDs indicate the constant parameter. The units may be operated in timed mode and will automatically terminate output. Continuous mode may also be operated.
• It is possible to perform electrophoresis with constant current whilst limiting the voltage to a selected value or with constant voltage  whilst limiting the current to a selected value.
• If one of the non controlling output set values is reached during the run, the power supply will automatically crossover and control the output relative to that parameter.
• Automatic RESTART in case of power failure during a cycle. When the power returns, an audible safety alarm rings for 10 seconds. Then the START mode turns on automatically at the preset values.
• Three safety outlets.
• These microprocessor controlled power supplies are equipped with a circuit breaker which automatically cuts the electrical supply in case of ground leakage detection, (500mA) short circuit, open circuit (no load connected) or overload.

1-200V
15µA-1998mA / 1mA