GENEQ > Biotechnology > Power Supplies

Power Supply
Model PS3002

FEATURES
  • 3000V, 300mA, 300Watts
  • Last settings are automatically restored at power up
  • Three rotative optical encoders for precise and easy input of parameters.
  • Three operating modes : Constant voltage, constant current, constant power.
  • Three red LEDs indicate the constant parameter.
  • Three push buttons permit selection of the following functions : START with green Led; STOP with red Led; PRESET for reading the preset values during electrophoresis.
  • Automatic RESTART in case of power failure during a cycle.
  • Recommended for DNA/RNA sequencing and agarose electrophoresis.
  • Three clear displays for reading the actual and preset voltage, current and power.
  • Two safety outlets.

It is possible to perform electrophoresis with constant modes whilst limiting the others to selected values, e.g: constant power whilst limiting current and voltage. Automatic crossover from one mode to another when preset output limits are reached. With the power returns, an audible safety alarm rings for 10 seconds then the START mode turns on automatically at the preset values.
This microprocessor  controlled power supply is equipped with a circuit breaker which automatically cuts the electrical supply in case of ground leakage detection, ( 500mA ) short circuit, open circuit ( no load connected ) or overload. A yellow blinking Led and an audible safety alarm ringing for 10 seconds indicate the FAULT situation.

SPECIFICATIONS
Output Range / Resolution 10-3000V / 10V
15µA-300mA / 1mA
0.3-300Watts / 1Watts
Max Power 300 watts
Min. Regulated Value 10V, 1mA, 1Watt
Value Display Range 0/3000V / 10V
0-300mA / 1mA
0-300watts / 1watt
Min. Output 10V, 15µA, 0.3W
Fault Detection Stop and Audible Alarm
Operating Temperature 0-40°C
Dimensions (WxDxH) 27 x 34 x 11
Weight 4kg

More informations on Applications and Specifications

CAT. NO. DESCRIPTION
120010 Power Supply for Nucleic Acid Sequencing, Model 3002