• 600Volt, 800mA, 300Watts
• Constant voltage
• Constant current
• Timer 0-9999 minutes
• Last settings are automatically restored at power up
• Settings by tactile switches

Two red LEDs indicate the constant parameter. The units may be operated in timed mode and will automatically terminate output. Continuous mode may also be operated. It is possible to perform electrophoresis with constant current whilst limiting the voltage to a selected value or with constant voltage  whilst limiting the current to a selected value. If one of the non controlling output set values is reached during the run, the power supply will automatically crossover and control the output relative to that parameter.
Automatic RESTART in case of power failure during a cycle. When the power returns, an audible safety alarm rings for 10 seconds then the START mode turns on automatically at the preset values. These microprocessor controlled power supplies are equipped with a circuit breaker which automatically cuts the electrical supply in case of ground leakage detection, (500mA) short circuit, open circuit (no load connected) or overload.