GENEQ > Environnement > Boues

Détecteur portatif du niveau des boues
Modèle 10 Sludge Gun®

FEATURES
  • Simple one hand operation (even when wearing gloves)
  • Self-storing cable spool (no tangles)
  • Useable at night (no ials to read)
  • Weatherproof case (Useable in the rain)
  • Spring loaded trigger turn gun off (Can't leave on & drain battery)
  • No light bulbs to change (100% solid state)
  • Over one year battery life (Normal service)
  • Thumb-adjustable sensitivity control (Easy to set)
  • Uses standard pencell batteries (Readily available)
  • Single plug-in style printed circuit board (Easily replaced if ever necessary)

Press the SLUDGE GUN® trigger and lower the probe. A loudspeaker on the butt of the gun howls when the probe enters the sludge. The pitch and volume will vary depending upon the sludge concentration so the unsettled portion above the blanket can also be detected. Read the sludge depth from the numbered markers on the cable.

HOW IT WORKS

When the trigger is depressed. high intensity burst of focsed infrared light are transmitted by a solid state LED (Light Emitting Diode) across a probe gap which contains either liquid or sludge. The highly penetrating infrared beam is received by a sensitive phototransistor on the other side of the gap. This pulsing is repeated many times per second by the electronic control circuit.

If the gap contains air or clear liquid nothing happens. However, when suspended solids are encountered in the gap, some beam energy is absorbed, and the rear facing loudspeaker on the butt of the gun starts to howl. As the percent solids content increases, both the pitch and volume of the sound increase which gives the operator a clear indication of where the thikest sludge is located.

By holding the trigger and listening to the note while slowly moving the probe up and down, the operator can observe the depth markers on the cable and establish the location of both the sludge blanket and the overlying unsettled layer.


EASY TO USE

The Sludge Gun® makes even an inexperience operator an expert at sludge detection. A trigger turns on the gun, and a thumb adjustable sensitivity control compensates for thin or thick sludges. There can be no mistaking the loud howl of the speaker as the probe enters the sludge bed. Variable pitch sound (higher pitch for higher % solids) permits locating both the upper and lower limits of the setting zone above the sludge bed.

After the use, the cable is wound on the self-storing spool at the front of the gun. The one hand, one piece, Sludge Gun® detector is easy for an operator t carry from tank to tank. Use it in the rain or snow, day or night. This rugged tool is a valuable addition to any plant.


SPECIFICATIONS
Weight 2kg (4-1/4 lbs)
Batteries 6 alkaline pencells
Battery Life One year (Normal service)
Probe Material PVC & Epoxy
Cable Material Vinyl jacketed
Gun Material PVC & Aluminum
Operating temperature -20°C (0°F) to 50°C (120°F)
Loudspeaker 3W, weatherproof type
Printed circuit board Epoxy-glass, moisture sealed, plug-in style
Sensitivity control Trip point can be adjusted from barely cloudy water, right up to the thickest sludge
Cable length 10 meters (33ft)
Cable markers Self adhesive vinyl (#1 to 30) Shipped loose for customer installation at either foor or meter readings