This pump is designed for in-line use. the pump consists of an aluminum diecast housing,
aluminum seal plate,nylon impeller and volute, stainless steel backplate, and Viton Gasket.
The pump uses a two-seal design.
the seals are double lip radial desigh type.One is mounted in the aluminum pump housing, the other is in the aluminun seal plate. The exposed motor shaft is stainless steel.The discharge is threaded (1/4" mnpt),the intake is also threaded (3/8" fnpt).
An adapter is icluded for the intake for 1/2" ID tubing.
The pump is designed for weak acids, mild chemicals, cleaning solvents,antifreeze, and potable fluids compatible with pump materials.
The pump can be used submerged when pumping water or machine oils and should only be used in-line (not submerged) when pumping weak acids. this pump is not self priming: it must be installed so that the pump head (volute) is flooded when the pump is started. that is, the inlet of the pump must be below the level of the surface of the liquid being pumped ( figure #1 )
 |
| Cat. No. |
Description |
| TEDB404-00 |
Pump for solvent (Trichloroethylene) |
e.jpg)