Your shopping cart is empty!
- Contact Us
Display unit and wind speed sensor with pre-alarm and alarm. Ideal in conjunction with the Anemo4403 sensor. Adaptable to a wide range of anemometer sensors. Pre-alarm (ALARM1) and Alarm (ALARM2).
|Designed for mounting on DIN 46 277 and EN 50 022 rails, such as in electrical cabinets. Especially designed for construction cranes. For installation on “PANEL” see the WM44-P model.|
Alarms can be programmed for the following: trigger values, intermittent or continuous, interlocked (only alarm2).
The alarm outputs are through voltage-free relay contacts. Choice between: on contact open or on contact close.
Possibility of alarm interlock 2. With the alarm disabled when the unit’s power supply is cut off.
Suitable for a wide range of sensors:
Power supply sensors: 20 V or 10 VDC, from the unit itself.
Types : 3-wire (20 V) and 2-wire (10 V). See wiring of faceplate connections from the unit itself.
We RECOMMEND pairing the unit with our Anemo4403 model.
PRESET USER PROGRAM CONFIGURATION.
In addition to user-programmed another, alternative programming can be saved in memory. This can be retrieved any time by going to the program step. P00 option 4.
230 VAC 50-60 Hz (other
voltages, please consult us)
(100 Hz =
100 km/h )
|Power consumption||< 3.5 VA||Maximum speed||999 km/h /620 mph|
Periodic square, sine-wave,
1 to 750 Hz . 5 to 35 VDC or 4 to
|Relay contacts||4 Amps 250 VAC.|
|Non-condensing relative humidity in accordance with IEC 68-2-3 and IEC 68-2-27|
-For Anemo4403 sensor or namur connection : 1000 Ω
-Direct: 10 kΩ
Shocks in accordance
with IEC 68-2-27
Types of input:
- Sensor mod. onix Anemo4403
- 3-wire sensors (pnp,npn..)
- Direct outside signal (see “Input signal” )
Vibrations in accordance
with IEC 68-2-6
|Output power supply sensors||10 or 20 VDC (+-10%)||IP protection level||IP20|
|Operating temperature||0 to 60 °C||Approximate weight||0.450 kg approx.|