Each of the water alarms features two stainless steel electrodes that are positioned at a desired point for liquid detection. When fluid is detected, a relay closes in the unit and the signal can be used to sound an alarm or close a switch inside a piece of remote monitoring equipment. The relay output is fully isolated and can handle 2 amps of current.
After the water alarm sensor is dried, the detection sensor will reset without requiring additional service. The level alarm is rugged and durable and requires minimal maintenance.
|Dimensions||1" diameter x 5"|
|Electronics||Solid state, fully encapsulated in epoxy.|
|Electrodes||304 stainless steel|
|Cable||4 wire shielded; 25' length (may be extended to 500')|
|Input Voltage||5VDC to 36VDC|
|Current Draw||Continuous 27mA, Active 44 mA|
|Alarm Output||Switch closure, 2 Amps Maximum Isolated Relay|
|GLWA600-00||Water Alarm Sensor|