Shopping Cart

0 item(s) - 0.00$
Your shopping cart is empty!
 
Drop us a line
Contact
 
T: 514-354-2511
T: 1 800 463-4363
F: 514-354-6948
Filter Station | Rotary Pilot Vacuum Filter Station from Tecniplant

Filter Station | Rotary Pilot Vacuum Filter Station from Tecniplant

Product Code:


Need more Info? (514) 354-2511 - 1-800-463-4363

Description
The Rotary Drum Vacuum Filter Station is composed by the following parts:

  • Nr. 1 Rotating Pilot Drum Vacuum Filter complete with agitator and sliding knife discharge. Filtrating Surface 0,1 m2.
    • Material of construction: AISI 316.
  • Nr. 2 Filtrate Tanks (~ 30 liters each) complete with level gauges.
  • Nr. 1 Liquid Ring Vacuum Pump.
    • Impeller Material: Bronze
    • Body Material: Cast Iron
    • Flow Rate: ~ 24 m3/h at ~ 300 mBarA
    • Service Water: 0,2 m3/h
  • Nr. 1 Set of valves and pipes for the complete connection and function of the Plant.
  • Nr. 2 Vacuum Gauges (one each tank).
  • Nr. 1 Electrical Panel to control the liquid ring vacuum pump, the vacuum rotary filter and the agitator.

 

Handling Operations and Storage
The Rotary Drum Vacuum Filter Station Handling operations indicated in this paragraph must be carried out by skilled personnel only. The people charged with Rotary Drum Vacuum Filter Station handling by use of cranes must know all the Health and Safety rules to carry out the loading, unloading and transporting of parts under the highest safety conditions.

The Weight of the Rotary Drum Vacuum Filter Station is about 150 Kg and use lifting means of suitable weight capacity and in conformity with safety regulations of the nation where the Rotary Drum Vacuum Filter Station is being installed.

The capacity of the lifting means must consider the max. protrusion allowed in addition to the weight of the parts.

Tecniplant declines any responsibility for damage to property and/or persons in cases of incorrect lifting.

Prevent any other person from standing nearby in order to avoid contact with any accidental falling parts or objects.

All of the area involved in Rotary Drum Vacuum Filter Station handling, including the vehicle’s apron and the place that will accommodate the Rotary Drum Vacuum Filter Station must be previously identified and inspected.

Check that the floor does not present exceptionally deep holes.

For correct unloading and handling operations the presence of two operators is recommended equipped with helmet, gloves, overalls and safety shoes.

These operators must pay the utmost attention to all the transport phases and remain at the proper distance from the Rotary Drum Vacuum Filter Station when their presence is not strictly necessary.

The operators involved with the lifting equipment must always follow suitable procedures. Particular care is needed when lifting the Rotary Drum Vacuum Filter Station to avoid it ending up out of control.

In operations of lifting the Rotary Drum Vacuum Filter Station, it must not be allowed to fall or tilt violently.

Care must be taken to stop objects of any kind from hitting the interior or exterior of the Rotary Drum Vacuum Filter Station or from falling onto it.

Never use cables or chains in direct contact with the Rotary Drum Vacuum Filter Station to carry out lifting operations.

Always avoid chains, hooks or the rocker arm oscillating or interfering with the Rotary Drum Vacuum Filter Station.

To unload the Rotary Drum Vacuum Filter Station from the transporter use a fork lift or a rocker arm. In case of rocker arm use a cable guide by hand to keep the load under control.

Do not cross or stand neither beneath the Rotary Drum Vacuum Filter Station nor on top.

Store the Rotary Drum Vacuum Filter Station indoors inside its wooden case.

 

Rotary Pilot Drum Vacuum Filter Station

 

Convertisseur d'unités